Mesi G3 mod V2

This Mesi G3 mod v2 was made by MJerry. All credits go to him.

 

First JeB penmod tutorial on my website, the Mesi v2 ! I found it on >Mesi’s blog<, so I think it’s the legit one 🙂

12 grams
20 centimeters

  • Stuff needed :
    – 1 Pilot plastic G3 (Backcap, barrel, tip, grip, inktube)
    – 1 Pilot Frixion [ the one with white barrel and tinted cap ] (Cap, rubber grip)
    – 3 Zebra D-1K (Grips) : only findable in Japan, try to trade with JeB people. Otherwise, you can sub it to Anyball grips
    – 1 Metallic Gel (Tip)
    – 1 Zebra Hyperjell (Grip)
    – 1 Sakura BallSign (Backplug)
    – 1 Hybrid Fine / Hybrid Gel Grip (Tip)
    – A small random grip (?)

 

  • Tutorial :

– Cap, part A :

  1. Put G3 backcap and Frixion rubber grip together like below :
    1
    2. Add a G3 4 stripes grip above the step 1. Don’t forget to cut the grip like that :

2

– Cap, Part B :

  1. Empty all the Frixion cap.
  2. Put the BallSign backplug into the top of Frixion cap and cut the backplug until to get that :

2011090620174767fSo, the black part on the top is a small part of BallSign backplug

3. Take the G3 inktube and keep only the grey part :

3

4. Then, put it on the top of Frixion cap :

5

– Cap, part C :

  1. Put the step 1 and the Hyperjell grip together like that :

6

2. Put this package grips into Frixion cap

7

– Barrel, front part :

1. Prepare the G3 front as all G3 mod (remove grip, the 8 small plastic squares and file the ruffle just near the tip)

2. Put G3 tip > Metallic gel tip > HGG tip

8

3. Add D-1K 15 stripes grips on the front : 5 red stripes > 4 black stripes > 6 red stripes

9

4. Add 2 red stripes and 4 black stripes of D-1K on the Frixion cap. (I am not sure about this step)

5. Put an insert into the barrel and put Frixion cap on the back of the G3. You have finished ! 🙂

Short combo with this mod, from Mesi.

 

 

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *